Linear Division
Access
You can assign the following elements to the linear division:
- Connection Situation
- Groove construction
- Divider in Article Designer
- Outline Geometry
- Inner contour
- Cross-section Geometry
- Single Parts
General Information
The linear division is a mathematical formula for the user to set it up individually which is suitable for every requirement by dividing any long line in different sections. The linear division is output as a string.
You can define the linear division with relative or absolute values. Absolute values have to be defined with a unit.
Example relative values:
1 : 1 > The distance will be divided into two sections with the same length.
Example absolute values:
100 mm : 1 > The first section will have a length of 100 mm The length of the second section depends on the total length.
Options
The following units of measurement may be used:
- mm
- cm
- m
- in (inch)
Linear division normally defines a position between 2 points. Points outside these two points can also be defined. This type of Linear division is used for the definition of Stretchable purchased parts and multiple parts.
Example: Length of the part = 1000 mm
-200 mm : 1 > Position at: -200 mm
-200 mm : 1 : -200 mm > Position at: -200 mm and 1200 mm
| Linear Division |
Enter a linear division. You can save entered Linear Divisions as templates/ examples in the database. Add a Linear Division as a template:
Choose a template: Select a saved template from the Linear Division combo box drop-down list. Delete a template: In the combo box drop-down list, click "Delete" (x) at the end of the line of the template you want to delete. |
| Descriptor | Via a click on the button behind the entry you can switch to the Element Manager where the view Descriptors are administrated. |
| Dimension Reference |
The dimensional reference regulates which of the three possible reference points for calculating the division are used. The reference points can be the outer or inner side of a part or the part axis. We differentiate between two reference points:
To change the reference point click on the illustration. |
| Total length |
With the help of the example length you can test the entered linear division. The result of the inserted value is shown by the drawing. |
| Thickness of dividers |
The thickness of the dividers also has an effect on the division. To test the division enter a value for the thickness. The result of the inserted value is shown by the drawing. |
| Apply | Apply the Linear Division defined or modified in the dialog. |
| Discard | Close the dialog without applying the Linear Division defined or modified in the dialog. |
Further information
For further examples read the Whitepaper Linear Division.