Groove editor

Access

> > Manager > Tab Details > Select machinings in the element window imos Methods window Grooves

Article Designer > Tab Part > Add machining > Dialog Machining > Grooves

General Information

Inserting, modifying or deleting a groove in a part can be made with the editor grooves.

Options

In the top section of the dialogue you can define the data of the groove. In the bottom section of the dialogue the data of the groove, that already exists in the part, is displayed in a list. By selecting a groove from the list in the bottom section, the fields in the top section of the dialogue are filled with the data of the selected groove.

Starting Point X X-coordinate of the insertion point.
Starting Point Y Y-coordinate of the insertion point.
Starting Point z Z- coordinate of the insertion point The insertion point depends on the orientation of the groove.
End Point X X-coordinate of the end point.
End Point Y Y-coordinate of the end point.
Endpoint Z Z-coordinate of the end point of the groove. The insertion point depends on the orientation of the groove. Depending on the orientation and direction one or two endpoints are blocked and contain the equal value as the starting point.
Linear Division The positioning of the groove can also be defined with linear division. The button is deactivated if the checkbox next to it is not activated. Above the button a dialog appears where a linear division for the insertion point respectively the end point in X, Y and Z can be entered.
Select The adjoining graphic also offers the opportunity to change the reference points, which is done by clicking on the graphic. The co-ordinate system is changed by selecting the corner points in the graphic. The entered coordinates then refer to this corner point. This makes it possible to enter relative modifications.
Depth Depth of the groove in mm.
Width Width of the groove in mm.
Orientation

Definition of the orientation of the groove.

The groove can have the following orientations:

  • TOP: vertical top
  • BOT vertical bottom
  • HXP horizontal (x positive)
  • HXN horizontal (x negative)
  • HYP horizontal (y positive)
  • HYN horizontal (y negative)
  • UNI Universal

Next to every selected orientation a graphic of this orientation scheme appears for a better overview. The four horizontal possible grooves refer to the grooves in the edges of a panel. The universal orientation allows the rotation of a workgroup through two axes. The input fields are activated as soon as the orientation UNI has been selected.

Rotation X Rotation angle of the groove in x-direction.
Rotation 0 Rotation angle of the groove in y-direction.
Rotation Z Rotation angle of the groove in z-direction.
Edge Profile Via a click on the button you change to the level of profiles in the Element Manager. You can select a profile and assign it to the groove.
Direction Direction of the groove. The selection of the direction (in X, in Y or in X and Y) influences the endpoint. The graphic in the dialogue visualizes the selected direction. The direction of the groove can also be selected by simply selecting on the graphic.
End form

End form of the groove.

This function is just activated for machining mill . Following values are possible:

  • Either
  • Square
  • Round
Add With this function manual modifications of a groove are effective. The set values in the top part of the dialog are taken for the current selected groove in the bottom list.
New Via this function you create a new groove. If you activate the function, a new groove with the set data in the top part of the dialog is inserted.
Delete Delete the groove currently selected in the list.