Article from contour

Access

Ribbon : Part Designer > Free Construction > Article from contour

General Information

Use this function to select an existing contour which is then used as outline geometry for an article. At the same time this outline geometry is saved with the same name in the Element Manager and can be subsequently edited there.

Procedure

After calling the function a dialogue will be opened, where you can define the name for the article and so also the name for the outline geometry. The article type defines on which view of the article the contour should be applied.

After that you will switch to the drawing area where you can select the contour/ polyline. When the contour is selected, the Article Designer opens with the selected contour.