Part Dimensions – Types of Dimensional References

Final/ Finished Dimensions

The final dimensions, also called finished dimensions, refer to the measurements of a panel after complete processing. The final dimensions indicate the measurements of the part as it will be installed, i.e., including edges and surface coatings.

If the part is NOT rectangular, a 'virtual' rectangle is drawn around the shape, which is used for dimensional references.

Raw Dimensions

The raw dimensions refer to the measurements of a panel before edge banding or after any initial formatting/sizing or edge jointing.

For rectangular panels, the raw dimensions are calculated from...

  • the final dimensions
  • minus the edge thickness

They indicate the measurements of the part for processing after initial sizing.

Since the part is typically already coated at this stage, the raw thickness is calculated from...

  • the thickness of the core material
  • plus the thickness of the coatings on top and bottom

Cutting Dimensions

The cutting dimensions refer to the measurements of a panel after cutting.

In general, the cutting dimensions are calculated from...

  • the length and width of the final dimensions
  • minus the edge thickness
  • plus an allowance for cutting/sizing

The cutting thickness is usually the same as the final thickness. (Before edge banding, the edge material thickness is milled off the edges of the cut panel. After edge banding, you get the final dimensions.)

The angle of a directional surface/coating is considered when calculating cutting dimensions. A rectangle is calculated with the X-axis aligned to the direction of the decor/veneer.