Contiguous Cutting Pattern Part
Access
iXplorer > Root element selected in The Elements Palette > Properties Palette > Methods tab
General Information
The method is available when selecting the root element. With it, you can generate cutting pattern parts where contiguous parts are explicitly aligned along a single axis. The parts are grouped by their material, surface and width. The core material that the parts should be nested into, is always the one closest to greater-equal part height. In the lower dialog section, you can see details about the core material chosen (if parts of different height are generated, the data of only one will be displayed).
See also Cutting pattern part .
Procedure
The function is optimized exclusively for contiguous parts (plinths, crown strips, light strips). It cannot be applied to part types other than contiguous parts.
- Select the root node in the iX Elements palette.
-
Click on the Generate Contiguous Part Cutting method in the iX Methods palette.
Info: The 3D orbit cannot be used to navigate while the method is active. Use the Viewcube instead.
- Select contiguous parts that are to be arranged in a cutting pattern part and confirm the selection by right-clicking. A configuration mask is loaded in the iX Properties palette.
- Configure the cutting pattern part. Click on Run (>>) to see a preview in the drawing area.
- To apply the configuration, click Run (>>) and then click Apply (checkmark). The cutting pattern part will be generated in the drawing area.
Options
| Method |
Choose an optimization mode:
|
| Border distance start | Part distance to the start point of the cutting pattern part. |
| Border distance end | Distance of parts from the end point of the cutting pattern part |
| Part distance | Distance between parts in the cutting pattern part. |
| Execute | Preview in the drawing area |
| Cutting material |
Selection box with fitting material principles If no core material fits, the list is empty. There will be no preview in the drawing area and a contiguous cutting pattern part cannot be generated. |
Fields in the lower dialog section, give you details about the cutting pattern part.
- Usable length
- Width
- Thickness
- Part count
- Overall length
- Cutting part count
- Waste [%]