Constructive connector characteristics - collision check for connectors*

Access

Ribbon : Main data > Main data > Element Manager > Connections > Connector

General Information

The constructive connector characteristics describe certain features of the connector. For example, you can modify the position of the connector in the article.

Options

Preview Characteristic-Name Values Explanation
Start point bounding box X (STARTPOINT_BOUNDING_BOX_X)

Number

(editable)

For drawer slides the set up cuboid will be generated on the left side normal and on the right side mirrored.

For hinges or mounting plate the set up data should be always tested with a left hinged situation because then the coordinate system is identical with the UCS.

For the same reason drawer slides should also be tested with left slides.

Start point bounding box Y (STARTPOINT_BOUNDING_BOX_Y)

Number

(editable)

see above
Start point bounding box Z (STARTPOINT_BOUNDING_BOX_Z)

Number

(editable)

see above
Endpoint bounding box X (ENDPOINT_BOUNDING_BOX_X)

Number

(editable)

see above
Endpoint bounding box X (ENDPOINT_BOUNDING_BOX_X)

Number

(editable)

see above
Endpoint bounding box Z (ENDPOINT_BOUNDING_BOX_Z)

Number

(editable)

see above
Collision-offset (COLLISION_GRID)

Text

(editable)

For automatic tool compensation for collisions.

Only those connectors are corrected that have assigned this attribute. The value of this attribute can contain several offsets that have to be divided with ";".

The connector will be offset along the connection-line (direction of the linear division). The single offsets are checked consecutively and the first matching value is used.

A positive offset is equivalent to an offset to the center point of the connection-line, so to the inside. A negative offset is equivalent to an offset from the center point of the connection-line away, so to the outside.

Collision-offset (COLLISION_GRID)

Text

(editable)

For automatic tool compensation for collisions.

Only those connectors are corrected that have assigned this attribute.

The value of the attribute can contain an offset.

The connector will be offset along the connection-line (direction of the linear division). The offset is tested several times, but maximum 100 times. The first matching value is used.

A positive offset is equivalent to an offset to the center point of the connection-line, so to the inside. A negative offset is equivalent to an offset from the center point of the connection-line away, so to the outside.

If the offset begins with +- or -+ , both directions will be tested. The closest position that fits is taken. In this case, maximum 200 trials will be performed. If the closest matching position have the same distance in the positive and negative direction, then the + is preferred for the positive and the - for the negative direction.

*) This function is optional and is not included in the basic version.