Pull Heights
Access
imos Ribbon : Main data > Main data > Element Manager > Hardware and Machinings > Pull Heights
Organizer > Tab Element Manager > Hardware and Machining > Pull heights
Options
| Pull Heights |
The heights of the height lines are dimensioned from Z=0 in the world coordinates. Via a click on the button behind the entry you can open an extra dialogue for the definition of the height lines. To create a new height line, enter it in the text field and save the value. Afterwards the height line is shown in the list. To delete a height line from the list, mark it and click the delete button. The list contains absolute numerical values or variables. |
| Activate height lines | You can activate Pull Heights with the function. This means that the handle is dragged to the height line if the distance of the handle is smaller than the entered snap radius. |
| Snap radius |
If the handle is within the defined snap radius, then it is dragged to the suitable height line. The snap radius always refers to the position of the height lines. If several height lines have been defined, make sure that the snap radius is not bigger than the distance between the height lines. |
| Gap top |
The entered value defines the minimum distance of the handle to the top edge of the front. If the minimum distance is less, the handle is not dragged to the height line. |
| Gap bottom |
The entered value defines the minimum distance of the handle to the bottom edge of the front. If the minimum distance is less, the handle is not dragged to the height line. |