Splitting line suggestions

For the iX function “Splitting principle with selection of cutting line”, the splitting line choices for worktops have been reduced to realistic suggestions and an additional type has been added. This declutters the drawing area in complex planning situations

Splitting cuts are suggested based on inside corners and cabinet joints. Mitre cuts are only suggested if the panels to be cut have identical depths.

Tip: New imos DCO package "Splitting Principles Version 2.0" available in iFurn DataBroker.

Suggested splitting lines along the depth

In addition, suggestions for splitting lines along the depth will be made from iX 2021 SR2 onwards. The possible depths are defined in the section Core Material of the Material principle.

Depth cuts are offered, for example, on corner panels, room divider panels or "extra deep" worktops.

In room divider situations (imos recognizes items that are placed back to back), a depth cut in the middle of the panel is also offered.

Another prerequisite for the use of depth cuts is that the panel is cut into a maximum of two panels by a depth cut.

The proposed splitting lines (blue) are parallel to the leading edge (base edge of the panel).

Different colors help to tell the types of cut suggestions apart:

  • Cut suggestions in length: Red
  • Cut suggestions at article/ cabinet joints: Green
  • Cut suggestions in depth: Blue