Create contiguous parts
Access
iXplorer > Select an article in the Elements palette > Properties palette > Index tab Methods > Contiguous parts
General Information
Methods for contiguous parts will appear in the palette when either an article or the root element is selected.
- Base panel
- Work surface
- Light valance
- Crown Molding
Procedure
After clicking on the function you will be asked to select the articles you would like to create contiguous parts for. If you have already selected articles this step would be skipped. The Properties palette will then display a Modifier dialog with the following options:
- Construction Rules
- Front offset
- Offset back
- Offset right
- Offset left
- Height (excluding worktops/ work surfaces)
- Vertical Offset
- Part thickness
The changes are applied/ discarded when clicking on the check mark/ cross in the top-right corner.
Modify Contiguous Part Parameters
A Contiguous Part is a parametric iX article. You can edit its properties by
switching to parametric mode:
- using the 'Edit Article' method
- by opening the Parametric tab in the iX Elements palette