PLAN Principle Selection

Access

Properties palette > Index tab Methods > Select an edge > Apply connector

Properties palette > Index tab Methods > Select a part > Cutting principle / ... as Inner Contour

Properties palette > Index tab Methods > Select an article > Contiguous part methods

Ribbon menu > Output > Load Border

Ribbon menu > Output > Annotate view

General Information

The Principle Selection dialog contains principles defined as favorites by the data creator. The dialog is available when clicking on the ellipsis button of one of the following properties in the Properties palette:

  • Border Frames
  • Lettering
  • Cutting principle
  • Connector
  • Surface

Select a principle from the list and click on the tick to apply it. Click the cross to cancel.