Modifier - edge-based Modifier
Access
iXplorer > Select an edge in the elements palette > Properties palette > Index tab Methods
Options
General Information
| Modify edge angle |
This function can rotate the selected edge by a defined angle. Refer also Modify edge angle . |
| Split Part Along Edge |
This function enables you to pick an edge of a part from where the part is divided with a defined angle. Refer also Split Part Along Edge . |
| Apply Connector |
Connector can be applied to an edge level without defining the connection situation. Refer also Apply connector to edge . |
Joint Functions
| Change Joint |
With this function you can change the trim of two edges. Refer also Change Joint . |
| Butt Joint |
This function can join the selected edge to another edge. Refer also Butt Joint . |
| Edge adjust |
With this function the contour of an edge from an imos part can be adjusted to another part. Refer also Edge adjust . |
| Extend to Polyline |
With this function you can apply the contour of a polyline to an edge. Refer also Extend to polyline . |
Move Functions
| Move |
This function can move the selected edge to a defined value. Refer also Move edge . |
| Move Starting Point |
With this function the starting point of an edge can be moved. The starting point of the selected edge is defined by the part. Refer also Move starting point . |
Contour Trim Functions
| Modify Corner |
In the upcoming dialog you can change the trim of the selected edges. Refer also Modify Corner . |
| Join edge |
With the support of this function you can join the selected edge with the previous or following edge. Refer also Join edge . |
| Split edge |
With the support of this function you can split the selected edge on a fixed point. Refer also Split edge . |