Loft part
Access
Ribbon : Part Designer > Free Construction > Loft-part
imos Manager : Tab Details > Methods > Free Construction > Loftpart
iXplorer > Select an element in the Elements palette > Properties palette > Index tab Methods > Free construction
General Information
Loft-parts are hyperparaboloidal parts. They are created with two bending lines which can be on different Z-levels.
Procedure
A loft part can either be created by picking two lines (polyline, splines etc.) or selecting two part edges.
After calling the function you are ask "1st and 2nd curve for the Loft Part"
Either two lines (polyline, spline, etc.) can be selected or two part edges.
After that it's possible to define the properties of the parts in the Manager.
Options
| Relative position |
For the relative position the following options can be selected:
|
| Part type | Choose one of the part types. The part type has an effect on the part position on the machine table and the edging. |
| Part Definition | Inside the combo box you can see the last part definitions. Via a cklick on the button behind the entry you can switch to the Element Manager where you can choose a part definition. |
| Part thickness |
The parameter is automatically filled with the thickness from the PD. You can change the value subsequently.
It only make sense to change the value if a material is used that was set up independently by the thickness, i.e. solid wood. In this case it makes sense to set the value of the characteristic Keep Thickness to Yes . For the event of a subsequently change of the material, the entered part thickness that is used for the graphical illustration, is not replaced by the default thickness of the assigned material. The normal case is the use of a material that is independent on thickness, i.e. PB19. The "part thickness" should not be changed in this dialog and "Keep Thickness" should be set on "No". This ensures that the thickness of new assigned material is also graphical used after changing the material of the part. |
| Create Manufacturing Data | You can define if manufacturing information for this part shall be created. |
| Keep Part Thickness | If you chose Yes, the value of the field Part Thickness will be used. Independent of the thickness of the used Part Definition. |