Free Construction - Part to edge

Access

Ribbon : Part Designer > Free Construction > Part to edge

iXplorer > Select an element in the Elements palette > Properties palette > Index tab Methods > Free construction

General Information

The function creates a part to an edge.

After you have started the function you will be invited to select an edge.

After that a dialog opens. In this dialog you can define the properties of the part.

If an article is selected in the imos Manager during the generation of a part, the new part will be assigned to this article.

Options

Face of part The function defines on which side the part is generated. Choose Bottom (right) or Top (left) out of the combo box.
Part type Choose one of the part types. The part type has an effect on the part position on the machine table and the edging.
Part Definition Inside the combo box you can see the last part definitions. Via a cklick on the button behind the entry you can switch to the Element Manager where you can choose a part definition.
Core material

By default the material from the defined Part Definition is used as the core material for the part.

Besides, another core material can be defined separately here as well.

When calculating the part thickness, the thickness of the core material with the coating from the Part Definition is added together.

Trim

With the settings you define the trims between the active edge and the attached edge of the new Part to edge .

For the trim you can choose between the following options:

  • Undefined
  • Mitre
  • Short
  • Long
Angle By entering a value in the field tilt angle, the selected part is tilted referring to the base area. A negative value effects a tilting into the carcase and a positive value out of the carcase.
Recess

The parameter moves the part by the inserted value. The SPP is moved into the part, based on the selected edge.

The new part is moved into the part, based on the selected edge.

Offset

The setting moves the new part by the defined value. The new part is moved away from the selected part.

There are two possibilities to define the value:

  • You can insert a value directly.
  • Via a click on the button you can switch to the drawing and pick a reference point that defines the value.
Part Height

The part height defines the dimensions of the the new part. The length of the part is defined by the selected edge.

There are two possibilities to define the value:

  • You can insert a value directly.
  • Via a click on the button you can switch to the drawing and pick a reference point that defines the value.
Protrusion bottom/ right

The protrusion of the new part defines the part length.

There are two possibilities to define the value:

  • You can insert a value directly.
  • Via a click on the button you can switch to the drawing and pick a reference point that defines the value.
Protrusion top/ left

The protrusion of the new part defines the part length.

There are two possibilities to define the value:

  • You can insert a value directly.
  • Via a click on the button you can switch to the drawing and pick a reference point that defines the value.
Part thickness

The parameter is automatically filled with the thickness from the PD, respectively the selected core material.

The thickness can also be changed subsequently.

It only make sense to change the value if a material is used that was set up independently by the thickness, i.e. solid wood.

In this case it makes sense to set the value of the characteristic Keep Thickness to Yes . For the event of a subsequently change of the material, the entered part thickness that is used for the graphical illustration, is not replaced by the default thickness of the assigned material.

The normal case is the use of a material that is independent on thickness, i.e. PB19. The "part thickness" should not be changed in this dialog and "Keep Thickness" should be set on "No". This ensures that the thickness of new assigned material is also graphical used after changing the material of the part.

Create Manufacturing Data You can define if manufacturing information for this part shall be created.
Keep Part Thickness If you chose Yes , the value of the field Part Thickness will be used. Independent of the thickness of the used Part Definition.
Rotate reference This function affects the position of the part on the machine table.