Connection Situation - Prefer biggest overlay

Question

Why do the connectors of an upper shelf and a side panel appear in the side panel located below instead?

Current state:

Target state:

Answer

Often, the Connection Situation is not interpreted correctly, if a shelf joins with two side panels stacked on top of each other or if a door edge rests on a side panel with a separate ending panel next to it.In your case, the lower partition panel probably joins with the shelf by a few millimeters, as well.Please try one of the following solutions:

  • move the upper shelf up a bit or make the lower partition panel smaller so that they no longer join together.
  • if the partition panels are different, exclude the lower panel using a Condition
  • apply the connectors manually

Starting with 13.0.02.211/ 14.0.01.107, you can use the option "Prefer biggest overlay" in the Connection Situation instead.

Example for the activated option:

  • Upper shelf joining with two partition panels:

    Overlay 1 > Overlay 2 --> Connectors are aligned with panel 1

  • Door resting on side panel with separate ending panel:

    Overlay 1 (positive value) > Overlay 2 (negative value) -->Fittings are aligned with panel 1

Stichworte: BLDR_LST C-Construction wrong Connection linked applied on double two sides tilted lopsided direction orientation oriented

Apr 2020 | 14.0.01.107, 13.0.02.211

#01241