Transfer AutoCAD Element-...Circle as Hole
Access
imos Manager > Tab Details > Select elements on part level > Transfer AutoCAD-Element > Circle as Hole
iXplorer > > select corresponding element > Properties palette > Methods Transfer AutoCAD-Elements
General Information
If an AutoCAD-Element is transferred as an circle, you must ensure that the AutoCAD-Element is on the same level as the part.
Procedure
By double clicking on the function, a request will appear to pick an AutoCAD-Element. After selecting the marked element, a new dialogue will appear for the exact definition of the drill.
Options
| Settings | The cutout can be defined either as continuous, or you can enter a fixed depth for it. If the option onset is selected, the entered depth has no effect. |
| Fixed Depth | The entered value defines the depth of the drilling. |
| Face of part | Determines whether the cutout is to be made from above or from below. |
Record modifier
These functions are associated with Modify Stack, and are only effective if the modified article was mapped using Stack and was then reconstructed with different measurements.
| Location of the Cutout |
Speed input
The distance between the drilling and the reference point remains the same after dimensional modifications to the part in X and Y directions. Relative in X and Y direction The distance between the drilling and the reference point is increased or reduced relatively in X and Y directions after dimensional modifications to the part. This means that the relationship between overall length X1 and distance A1 remains the same as that between overall length X2 and distance A2. Relative in X direction The distance between the drilling and the reference point is increased or reduced relatively in X direction after changes to the measurements of the part. Relative in Y direction The distance between the drilling and the reference point is increased or reduced relatively in Y direction after changes to the measurements of the part. |
| Reference point |
Definition of the reference point for the drilling on the part. After selection, the mouse switches to Snap, and the desired point may be clicked in the drawing. This must be a point that is on the part to which the drilling is being applied. |