Extend Surface to Polyline
Access
iXplorer > Properties palette > Index tab Methods > Select a part > Extend Surface to Polyline
General Information
You can bend a part along a polyline. Therefore it is necessary that the polyline is drawn on the level of a part's edge.
Options
| Face of part |
Offset of the part in vertical direction. Defines whether top or bottom side of the origin is used as reference. |
||
|
|||
| Offset | Offset of the part in positive or negative direction. | ||
|
|||
| Project size | Defines whether the part will be bend along the complete polyline or just along the part that is on the same projection level. | ||
|
|||
| Connection Scan | Yes: Connection will be assigned via Connection Scan. |