Rectangular pocket in part definitions

Access

Element Manager > Parts > Part Definition > Part Editor > Machining tab

Element Manager > Parts > Stretchable Purchased Parts > Part Editor > Machining tab

Options

Orientation

Defines the orientation of the rectangular pocket.

The rectangular pocket can have the following orientations:

  • TOP: vertical top
  • BOT vertical bottom
  • HXP horizontal (X positive)
  • HXN horizontal (X negative)
  • HYP horizontal (Y positive)
  • HYN horizontal (Y negative)
  • UNI Universal

For better visualization, the selected orientation scheme is displayed in the adjacent graphic for each chosen orientation. Only a universal operation can be rotated around three axes. The input fields are enabled once the UNI orientation is selected.

Orientation X

Rotation angle of the rectangular pocket around X

Depending on the selected orientation, the value is either predefined or can be freely chosen.

Orientation Y

Rotation angle of the rectangular pocket around Y.

Depending on the selected orientation, the value is either predefined or can be freely chosen.

Orientation Z

Rotation angle of the rectangular pocket around Z.

Depending on the selected orientation, the value is either predefined or can be freely chosen.

Linear Division

The position of the rectangular pocket can either be defined with fixed values for the start points in X, Y and Z or with a linear division.

If the checkbox 'Linear Division' is ticked, the X, Y and Z values can be defined using descriptors respectively.

Click the three-dot button to go to the Descriptors.

Starting Point X

X-coordinate of the insertion point.

Can also be defined by descriptors.

Starting Point Y

Y-coordinate of the insertion point.

Can also be defined by descriptors.

Starting Point z

Z- coordinate of the insertion point The insertion point depends on the orientation.

Can also be defined by descriptors.

Length

Length of the rectangular pocket in mm.

Can be defined as variable number.

Width

Width of the rectangular pocket in mm.

Can be defined as variable number.

Depth

Depth of the rectangular pocket in mm.

Can be defined as variable number.

Corner radius

The corners of the rectangular pocket are rounded by the entered value.

The entry is shown in mm.

Can be defined as variable number.

Edge Profile You can select a profile and assign it to the rectangular pocket. Click the three-dot button to go to the 'Profiles'.

Technology Data The technology data can be used to define the tool used for machining.
Tool

Enter the tool name of the tool used.

CAMMAX tools cannot be used here.

Feed rate XY Machining Feed in m/min
Feed rate Z Feed rate for the start point of the routing in Z-direction.
Speed Speed of the tool in U/min
Infeed Infeed in mm