Lineborings in part definitions

Access

Element Manager > Parts > Part Definition > Part Editor > Machining tab

Element Manager > Parts > Stretchable Purchased Parts > Part Editor > Machining tab

Options

Orientation

Defines the orientation of the lineboring.

The lineboring can have the following orientations:

  • TOP: vertical top
  • BOT vertical bottom
  • HXP horizontal (X positive)
  • HXN horizontal (X negative)
  • HYP horizontal (Y positive)
  • HYN horizontal (Y negative)
  • UNI Universal

For better visualization, the selected orientation scheme is displayed in the adjacent graphic for each chosen orientation. Only a universal operation can be rotated around three axes. The input fields are enabled once the UNI orientation is selected.

Orientation X

Rotation angle of the lineboring in X-direction.

Depending on the selected orientation, the value is either predefined or can be freely chosen.

Orientation Y

Rotation angle of the lineboring in Y-direction.

Depending on the selected orientation, the value is either predefined or can be freely chosen.

Orientation Z

Rotation angle of the lineboring in Z-direction.

Depending on the selected orientation, the value is either predefined or can be freely chosen.

Linear Division

The position of the lineboring can be defined with fixed values for the start points in X, Y and Z or with a linear division.

If the checkbox 'Linear Division' is ticked, the X, Y and Z values can be defined using descriptors respectively.

Click the three-dot button to go to the Descriptors.

Starting Point X

X-coordinate of the start point of the lineboring.

Can also be defined by descriptors.

Start point Y

Y-coordinate of the start point of the lineboring.

Can also be defined by descriptors.

Start point Z

Z-coordinate of the start point of the lineboring. This start point depends on the orientation of the lineboring.

Can also be defined by descriptors.

End Point X

X-coordinate of the end point of the groove.

Can also be defined by descriptors.

End Point Y

Y-coordinate of the end point of the groove.

Can also be defined by descriptors.

Endpoint Z

Z-coordinate of the end point of the groove. This end point depends on the orientation of the lineboring.

Can also be defined by descriptors.

Depth

Depth of each hole in a lineboring in mm.

Can be defined as variable number.

Diameter

Depth of each hole in a lineboring in mm.

Can be defined as variable number.

Grid The grid defines the distance between the holes of a lineboring.
Grid reference The lineboring can run in X, Y and diagonal direction.