Grooves in part definitions
Access
Element Manager > Parts > Part Definition > Part Editor > Machining tab
Element Manager > Parts > Stretchable Purchased Parts > Part Editor > Machining tab
Options
| Orientation |
Defines the orientation of the groove. The groove can have the following orientations:
For better visualization, the selected orientation scheme is displayed in the adjacent graphic for each chosen orientation. Only a universal operation can be rotated around three axes. The input fields are enabled once the UNI orientation is selected. |
| Orientation X |
Rotation angle of the groove in X-direction.
Depending on the used orientation the value is already predefined or can be freely selected. |
| Orientation y |
Rotation angle of the groove in Y-direction.
Depending on the used orientation the value is already predefined or can be freely selected. |
| Orientation Z |
Rotation angle of the groove in Z-direction.
Depending on the used orientation the value is already predefined or can be freely selected. |
| Linear Division |
The position of the groove can either be defined with fixed values for the start points in X, Y and Z or with a linear division. If the checkbox 'Linear Division' is ticked, the X, Y and Z values can be defined using descriptors respectively. Click the three-dot button to go to the Descriptors. |
| Starting Point X |
X-coordinate of the insertion point. Can also be defined by descriptors. |
| Starting Point Y |
Y-coordinate of the insertion point of the circular pocket. Can also be defined by descriptors. |
| Starting Point Z |
Z- coordinate of the insertion point. The insertion point depends on the orientation. Can also be defined by descriptors. |
| End Point X |
X-coordinate of the endpoint of the groove. Can also be defined by descriptors. |
| End Point Y |
Y-coordinate of the end point of the groove. Can also be defined by descriptors. |
| Endpoint Z |
Z-coordinate of the endpoint of the groove. This point is determined by the orientation of the groove. Depending on the orientation and direction, one or two endpoints may be locked and will have the same value as the starting point. Can also be defined by descriptors. |
| Depth |
Depth of the groove in mm. Can be defined as variable number. |
| Width |
Width of the groove in mm. Can be defined as variable number. |
| Edge Profile | You can select a profile and assign it to the groove. Click the three-dot button to go to the 'Profiles'. |
| Machining | You can choose between Saw and Mill. |
| End form |
Final form of the groove. This function is only enabled in the Mill mode. The following values are possible:
|