Part dimensioning: Choose a projection method

By default, imos iX chooses the projection method to be used in the Document Manager, based on the unit of measurement (mm/ inch ) set in imos iX.

As of iX 2021 SR2 you can set the type of projection method independently. To change this system setting, please contact the imos service hotline.

Possible pre-sets are:

  • Choose projection method based on the unit of measurement (mm/ inch ) set in imos iX (default)
  • Always use projection method according to the EU standard (first-angle projection.
  • Always use projection method according to the US standard (third-angle projection).

Projection method 1 (European / first-angle projection):

Projection method 3 (American / third-angle projection):