Article Designer - Connection Situation

Access

Ribbon : Designer > Article > Top View/ Front View/ Side View

General Information

Connectors can be fitted between parts via the tab Connector situation. Multiple connectors can be loaded together.

The tab Connections is available if shelves, sides, front or back are marked in the element window.

If a connection situation is defined at this place, the corresponding element is marked with a white plus in the upper element window.

Options

Previous

The previous (predecessor) to the selected part is evaluated counter-clockwise.

The Dropdown box contains the last used connections. If you select one of the connections, it is allocated to the part. To open the Element Manager and select a connection situation, click the ellipsis button.

By clicking the other button, the direction of the linear division can be reversed. The linear division is responsible for the position and the numbers of each connector.

Right-click in the entry field to change the definition to variables.

A variable from the type number must be chosen for the definition.

The value of the variable must be either 0 or 1.

0 = Connection situation is not set

1 = Connection situation is set

Next

The next (successor) to the selected part is evaluated counter-clockwise.

The Dropdown box contains the last used connections. If you select one of the connections, it is allocated to the part. To open the Element Manager and select a connection situation, click the ellipsis button.

By clicking the other button, the direction of the linear division can be reversed. The linear division is responsible for the position and the numbers of each connector.

Right-click in the entry field to change the definition to variables.

A variable from the type number must be chosen for the definition.

The value of the variable must be either 0 or 1.

0 = Connection situation is not set

1 = Connection situation is set

To Top/ Bottom Shelf The connections to the top/bottom shelf can only be set for the construction in the topview .
To door/ back panel The connections to the door/back panel can only be set for the construction in the frontview .
To left side/ right side The connections to the left side/ right side can only be set for the construction in the side view .
To dividers

The Dropdown box contains the last used connections. If you select one of the connections, it is allocated to the part. To open the Element Manager and select a connection situation, click the ellipsis button.

By clicking the other button, the direction of the linear division can be reversed. The linear division is responsible for the position and the numbers of each connector.

Add machinings

With the function you can add different machining manually to the part. After calling the function the dialogue Machining editor will open. The shown sample dimensions comply with the dimensions of the selected parts. Below is a table with the possible machining. Next to the respective machining the number how often the machining has been added to the part is shown.

Click on the button next to the required machining to create a new machining.