Article Designer - Base

Access

Ribbon : Designer > Article > Top View/ Front View/ Side View

General Information

The iX article can be designed with a base. The base you assign is always a Contiguous Part (principle).

Options

Insert base

In this field you define when a toekick is created.

No

Never means that no toekick is created even if a base is defined in the Design Parameters.

Yes

Always means a toekick is always created, even if it is not defined in the Design Parameters.

If there is no construction principle for the base selected, the bottom shelf will be raised anyway to the default height from the Design Parameters.

Take from design parameters

The toekick is inserted in accordance with the default in the Design Parameters.

Toenotch

With this function a notch can be automatically added to the front and back edge of the side panel. The dimensions of the notch are defined in the Design Parameters.

Yes

Never means that no notch is created even if it is defined in the Design Parameters. If there is no construction principle for the base selected, the bottom shelf will be raised anyway to the default height from the Design Parameters.

Take from design parameters

The toenotch is inserted in accordance with the default in the Design Parameters.

No

Never means that no notch is created even if it is defined in the Design Parameters.

Inset base

If the flag "Inset Base" is activated, the side panels will go all the way to the floor so that an integrated toekick can be constructed.

To define which side panels go all the way to the floor, the right and left connecting sides must have been defined in the parts folder for articles in the top view.

Base panel Via a click on the button behind the entry you can switch to the Element Manager where you can choose a construction principle.
Base Height Compensation

The Base Height Compensation field defines how toekick installation affects the zone dimensions and height of the cabinet article. There are three options available: The type of height division is displayed in an image below the selection window.

Scale all zones

All zones are aligned so that the additional dimension of the base on all zones is divided. The alignment is on the basis of the linear division. The total height of the cabinet is not changed.

If the article is designed in the front view and a contour is applied, this setting is relevant to the article contour as well.

Increase total height

The overall height is increased by the toekick height. The heights of the individual zones do not change.

Align all zones but retain the contour

All zones are aligned so that the additional dimension of the base on all zones is divided. The alignment is on the basis of the linear division. The height and the contour of the cabinet are retained.

Base height

The Base Height field defines how the height of the base construction is determined and there are three options available:

Default

Default references the toe notch dimensions set in the Design Parameters.

From CP

From CP references the toekick height in the Toekick Construction Principle.

Fixed value

Fixed Value references the dimension entered in the field to the right of this option. The fixed value can be defined with a variable number.

Adjust lineboring

Adjust lineboring is enabled when the flag "Inset Base" is active.

Setting this flag adjusts lineboring to the height of the base.