Article Category
Access
imos Ribbon : Main data > Main data > Element Manager > General Rules
Organizer > Tab Element Manager > General Rules
General Information
Via the article category the connecting point or connecting points of the article can be defined. In addition it is possible to define if contiguous parts should be directly inserted for the article as well.
Article categories can be assigned to an article via the Article Designer or to an Object Designer article via the Details tab of the imos Manager.
Options
Default settings
| Notes | Editable text field. |
| Use this principle as default |
No more than one principle can be defined as default. The behavior is as follows:
|
Catch
The insertion point for the article mode can be defined via the node Catch. It is also possible to define several connecting points.
If possible, snap points should always be defined on two sides so that the article chain functions.
Contiguous Parts
Via the node contiguous parts it is possible to define if a contiguous part, a base, work surface, light valence, crown molding should always be inserted with the article.
When inserting the article, the quick entry mode must be activated so that the contiguous parts defined via the article category can be inserted in the drawing.
Contiguous Parts can be operated via variables.
Insertion position
| Insertion height | Defines the insertion height of the article. |
| Height reference point | Defines whether the article is inserted above or below the insertion height. |
| Not stretchable | When enabled, the article cannot be stretched. By default, Articles that no Article Category is assigned to are stretchable. Be default, the box is notchecked. The effect of the switch: Users can no longer apply the methods "Stretch article" or "Stretch article line" on respective articles. While inserting, moving or copying an article, the function for "Stretch article" as well as the dialog "Insert options" are no longer available. |
Drawing output
| Planview layer |
The defined layer is evaluated by the 2D Plan View- section optionArticle Contours . The entered layer must exist in the DWT or in the used drawing. |