Dimensioning principles- Info text
Access
Ribbon : Main data > Tools > Dimensioning principles Dimensioning principles
General Information
The info text for the single workgroup type can be defined via the register Info text .
If no information for a part type has been defined as output in the register workgroup , then the settings in this register are irrelevant.
Options
Information text output
| Horizontal | Texts are issued horizontally only. |
| Vertical | Texts are issued vertically only. |
| Horizontal/ Vertical | Texts are issued in both directions. |
| None | No information texts are output. |
Information text
| Information text |
A text for measuring can be added to each workgroup, i.e. D for diameter when sizing the bore. D = diameter T = depth W = width LG = lineboring grid |
| Structure of the Info text |
{SYMBOL} or {SYMBOL/UNIT} {SYMBOL{TEXT1} ADDITION {TEXT2}} or {SYMBOL{TEXT1} ADDITION {TEXT2} /UNIT} |
| SYMBOL | The information which will replace the expression |
| UNIT | The unit of measurement. |
| ADDITION | Comment, for instance a unit of measurement. |
Valid expressions for SYMBOL
| D | Diameter of Hole |
| B | Groove width |
| LR | Lineboring Grid (Spacing) |
| LN | Number of Holes of a Lineboring |
| LX | horizontal distance of the Holes of a Lineboring |
| LY | vertical distance of the Holes of a Lineboring |
| T |
Depth of a Hole or Groove Not continuous Hole/ Groove: Expression is replaced by TEXT1 and the value of depth is added Continuous Hole/ Groove: Expression is replaced by TEXT2. |
| R |
Direction If the Hole/ Groove is inserted from the front of the part, the expression is replaced by TEXT1. If the Hole/ Groove is inserted from the back of the part, the expression is replaced by TEXT2. |
Valid expressions for UNIT
| m | meter |
| cm | centimeter |
| mm | millimeter |
| zm | tenth millimeter |
| hm | hundredth millimeter |
If UNIT is not entered, mm is taken for unit of measurement as a default. In this case {SYMBOL} is equal with {SYMBOL/mm}
Infotext with Inch
If the units for the Info text are changed, then the values will change accordingly. When writing, it is important to remember that the slash comes first and then the unit is entered.
The following units are permitted:
m, dm, cm, mm, zm, hm and in
So the definition of the Info text for converting the lineboring into inches could look like this:
R={LR/in}; D={D/in}, {T{T=} {continuous}/in} {R{} {bottom}} quantity:{LN}